Author |
Topic Search Topic Options
|
smacky
Guest
Joined: May 12 2010
Location: SaratogaSprings
Status: Offline
Points: 266
|
Post Options
Thanks(0)
Quote Reply
Topic: A Little Problem Posted: March 15 2011 at 11:25pm |
It really is a small problem, like an inch and a half. The only problem is that is how far I need to move my tank. I got a cabinet that was PERFECT for top off water, power strips, ballasts etc. and I was sure it would fit in the space I had for it... It doesn't fit, and now I have to move a 46 gallon tank with sump and stand and everything about an inch and a half to the left.
How would you do it?
Edited by smacky - March 15 2011 at 11:29pm
|
 |
wickedsnowman
Guest
Joined: April 09 2010
Location: Ogden
Status: Offline
Points: 865
|
Post Options
Thanks(0)
Quote Reply
Posted: March 15 2011 at 11:36pm |
Drain it down as much as you can and get a few dudes to help.If you do it fast enough it wont kill anything just piss it off for a few days. Make sure you lift and not push. Tanks are very top heavy and a stand will break before it slides.
|
 |
bfessler
Guest
Joined: March 13 2009
Location: Lehi
Status: Offline
Points: 1708
|
Post Options
Thanks(0)
Quote Reply
Posted: March 16 2011 at 8:19am |
What type of floor is it sitting on? If it's not on a carpet you may just be able to slide it over. I had a similar situation on my frag tank which had over 100 gallons. I was setting up my skimmer on the side of the rack and it was 1" to close to the door to allow it to close. I just sat next to the tank and braced myself using my legs to push it from the bottom of the rack. I was able to move the whole system without draining any of it. This was a steel rack on a concrete floor though so be careful I wouldn't want you to break your stand or damage your floor either.
This is what I had to move. 
|
Burt
An equal opportunity reefer,
I support all hobbyists and organizations involved in Marine Aquarium Keeping.
[email protected]
|
 |
jmw
Guest
Joined: February 12 2009
Location: perry
Status: Offline
Points: 433
|
Post Options
Thanks(0)
Quote Reply
Posted: March 16 2011 at 10:08am |
cut the cabinet
|
 |
smacky
Guest
Joined: May 12 2010
Location: SaratogaSprings
Status: Offline
Points: 266
|
Post Options
Thanks(0)
Quote Reply
Posted: March 16 2011 at 10:41am |
It's carpet.
|
 |
Crazy Tarzan
Guest
Joined: September 12 2003
Location: Riverton, WY
Status: Offline
Points: 1681
|
Post Options
Thanks(0)
Quote Reply
Posted: March 16 2011 at 11:01am |
drain the tank down as far as you can, then lift and move. Did it with my BC29 all by myself, but with the 46 I'd get a couple big guys to do it for me.
|
Was that in there yesterday? Casper--WY windier than ?
Down to a 20, soon to double or nothing
|
 |
Mark Peterson
Paid Member
Joined: June 19 2002
Location: Murray
Status: Offline
Points: 21436
|
Post Options
Thanks(0)
Quote Reply
Posted: March 16 2011 at 5:34pm |
If you drain it half way and lift up and pull/drag it over. Burt the muscle man.
|
Reefkeeping Tips, & quick, easy setup tricks:www.utahreefs.com/forum/forum_posts.asp?TID=9244 Pay it forward - become a paid WMAS member
|
 |
BnK
Guest
Joined: February 05 2011
Location: Layton,Ut
Status: Offline
Points: 776
|
Post Options
Thanks(0)
Quote Reply
Posted: March 17 2011 at 12:42am |
let me know what you figure out. I have to move my 95gallon from one wall to the wall across the room. And dont have any idea how to without emptying it
|
|
 |
smacky
Guest
Joined: May 12 2010
Location: SaratogaSprings
Status: Offline
Points: 266
|
Post Options
Thanks(0)
Quote Reply
Posted: March 17 2011 at 8:32am |
Here's what I think I'm going to do. I'm going to scoop out and empty the return and skimmer sections of my sump, then take about half the water out of the fuge and display tank. Then I'll have my dad and two brothers-in-law help me move it over a bit. I think it won't be a problem. I'll let you know how it all goes. Thanks for the suggenstions
|
 |
bfessler
Guest
Joined: March 13 2009
Location: Lehi
Status: Offline
Points: 1708
|
Post Options
Thanks(0)
Quote Reply
Posted: March 17 2011 at 8:48am |
Brett
Moving a 95 across the room is a whole different story than moving a 43. The weight of the tank, sand and rock alone will make it difficult to move the tank without draining it and removing the live rock from the display. You are going to have to treat this just like you were moving the tank across town. Here is a link with some good suggestions on moving the tank.
|
Burt
An equal opportunity reefer,
I support all hobbyists and organizations involved in Marine Aquarium Keeping.
[email protected]
|
 |
smacky
Guest
Joined: May 12 2010
Location: SaratogaSprings
Status: Offline
Points: 266
|
Post Options
Thanks(0)
Quote Reply
Posted: March 20 2011 at 12:26pm |
I drained the fuge and took about half of the water out of the DS and got it moved with some help from brothers-in-law. I also got a free lesson. When you're moving ballasts and things around and squeezing them into new drawers, unplug them. That was the first time I tripped a 15 amp circuit on myself, it was quite an experience. I don't recommend it. Unplugging the lights first and plugging them back in last it a good idea.
|
 |
WhiteReef
Paid Member
Joined: September 03 2002
Location: Magna, UT
Status: Offline
Points: 1014
|
Post Options
Thanks(0)
Quote Reply
Posted: March 20 2011 at 4:35pm |
Glad to hear you got it moved okay, although the lesson learned probably you could have done without.
|
----------------
Richard
Former 47G Column Reef, Magna 20" x 18" x 31"H
|
 |
Mark Peterson
Paid Member
Joined: June 19 2002
Location: Murray
Status: Offline
Points: 21436
|
Post Options
Thanks(0)
Quote Reply
Posted: March 20 2011 at 9:57pm |
 Glad you're okay.
|
Reefkeeping Tips, & quick, easy setup tricks:www.utahreefs.com/forum/forum_posts.asp?TID=9244 Pay it forward - become a paid WMAS member
|
 |