Print Page | Close Window

Eshopps 300 Snowcone Skimmer

Printed From: Utah Reefs
Category: Specialized Discussion
Forum Name: Equipment
Forum Description: This is the place to ask question about reef equipment.
URL: http://www.utahreefs.com/forum/forum_posts.asp?TID=76856
Printed Date: June 08 2026 at 11:35am
Software Version: Web Wiz Forums 12.03 - http://www.webwizforums.com


Topic: Eshopps 300 Snowcone Skimmer
Posted By: Fishflop
Subject: Eshopps 300 Snowcone Skimmer
Date Posted: July 19 2015 at 1:12pm
I have a eshopps 300 Snowcone skimmer that repeatedly keeps overflowing on me. The manufacturers directions say it works best in 8-10" of water, and I have mine sitting at 9 with the outflow being 100% open. If the tank water is messed with at all (dosing, fans kicking on, water change) it starts to foam like mad and blow crap all over the place. The only thing can think is to raise the skimmer even more, but if I end up doing that then it's going to be touching the top of my stand.. These skimmers are frustrating.



Replies:
Posted By: Reefer4Ever
Date Posted: July 19 2015 at 3:54pm
How long has it been running? Does it have a good slime coat inside it? Definitely raise higher out of the water. Close down your air line a bit if need be

-------------
90 gal reef w/refugium
24 gal softie tank
11 gal nano anemone tank
5 gal fresh water


Posted By: Fishflop
Date Posted: July 19 2015 at 3:59pm
It's been on the tank for 2-4 weeks now, it doesn't have a airline intake reducer and it has a really.. Really good slime coat.. It's just whenever the water is touched it goes into a foam frenzy lol


Posted By: Indu
Date Posted: July 19 2015 at 8:14pm
I don't have any suggestions except turn off the skimmer during water changes.

OT: I usually clean that slime coat away when I dump the skimmate. Am I not supposed to do that?


Posted By: Fishflop
Date Posted: July 19 2015 at 8:16pm
It'll do the foaming either way, and the slime cost is pretty much the result of the "break in" period that everyone needs for their skimmer to pull proteins =)


Posted By: Marcoss
Date Posted: July 19 2015 at 8:24pm
Mine did the same exact thing for about 5-6 weeks before it was broken in. I am not really sure what breaking in means though; I was always under the impression that it took several weeks for the shipping oils/manufacturing oils to be cleaned away for the skimmer to start working. 

Mine would be fine for several hours and then suddenly act up. It finally stopped after a period of time. 

Are you dosing into the skimmer area or the return? Assuming they are separate. I wonder if dosing further away would help eliminate at least one pain in the butt foam up. 

I am not sure if this has anything to do with it, but I personally noticed that one of my tanks, with a super oversized skimmer started working like a champ after a few days, whereas the one with an underpowered skimmer took forever. Too many variables (brand/ratio of water to skimmer capacity/more advanced) to know if that has anything to do with it, but just another idea.


-------------
RedSea Max S400 - 90G Rimless Frag Tanks x2 - 185 Lookdown Bin



Print Page | Close Window

Forum Software by Web Wiz Forums® version 12.03 - http://www.webwizforums.com
Copyright ©2001-2018 Web Wiz Ltd. - https://www.webwiz.net