Print Page | Close Window

Drilling Holes

Printed From: Utah Reefs
Category: Main
Forum Name: General Discussion
Forum Description: Posts that don't fit in any of the other categories.
URL: http://www.utahreefs.com/forum/forum_posts.asp?TID=45083
Printed Date: March 14 2025 at 4:57pm
Software Version: Web Wiz Forums 12.03 - http://www.webwizforums.com


Topic: Drilling Holes
Posted By: SGH360
Subject: Drilling Holes
Date Posted: December 01 2010 at 9:40pm
well i was wondering how to drill a hole to a acrylic?



Replies:
Posted By: Jake Pehrson
Date Posted: December 01 2010 at 10:09pm
I use regular hole saw to drill acrylic.  Start drilling from one side apply very little pressure (if not you can catch the saw and crack the acrylic).  When you are about 1/2 through the acrylic drill the rest from the other side (you should have a pilot hole so your holes should match up exactly in the center).

-------------
Jake Pehrson

Murray

http://coralplanet.com" rel="nofollow - coralplanet.com

http://utahbeeranch.com" rel="nofollow - :)


Posted By: CapnMorgan
Date Posted: December 01 2010 at 10:19pm
Originally posted by Jake Pehrson Jake Pehrson wrote:

I use regular hole saw to drill acrylic.  Start drilling from one side apply very little pressure (if not you can catch the saw and crack the acrylic).  When you are about 1/2 through the acrylic drill the rest from the other side (you should have a pilot hole so your holes should match up exactly in the center).

Exactly. That way you don't get chips on the acrylic. If it's 3/8" or thicker you may also consider keeping it wet while you drill it, otherwise it can start to melt from the heat of the hole saw.


-------------
Steve
http://utahreefs.com/forum/forum_posts.asp?TID=40637&PID=356246" rel="nofollow - My Old 180G Mixed Reef
Currently:
120G Wavefront Mixed
29G Seahorse & Softies
Running ReefAngel Plus x2
435-8


Posted By: Jake Pehrson
Date Posted: December 02 2010 at 11:50am
Steve,
 
I had thought I had mentioned the melting thing, but I didn't.  It is a very good point.  I usually don't use water, but you can.  If the acrylic starts to melt then I usually stop and wait until it cools down.  Usually if you have a sharp hole saw and don't push too hard it won't melt.


-------------
Jake Pehrson

Murray

http://coralplanet.com" rel="nofollow - coralplanet.com

http://utahbeeranch.com" rel="nofollow - :)



Print Page | Close Window

Forum Software by Web Wiz Forums® version 12.03 - http://www.webwizforums.com
Copyright ©2001-2018 Web Wiz Ltd. - https://www.webwiz.net