Ok, I purchased a replavement heater and was about to mount the
controller on the wall, grabbed my hammer and Ohhhhh, Noooo bumped the
corner of the tank. It cracked and there is a hairline crack heading
the other way (About 1 inch long).
Ok, currently there is no leaking, but with a 10 gallon is there enough
water pressure to further crack it causing it to leak, or will I be OK.
If I should replace I am think I might as well go with a larger tank like a 20 gallon.
Since my 10 gallon is cycled and I am just waiting for the diatom to go
away. If I switched over to a 20 gallon, it would not cause the cycle
to start over if I use the same rock, water and sand (Of course I will
add more water and more sand)
(I added the picture to my journal thread, and removed from here)
Man this just bumbs me out.
Rob
Rob
Edited by Robudda
Topic Options
Post Options
Thanks(0)
. I say go with the upgrade. That crack would always be on the back of my mind.
Jared Wood wrote:
